ISO INTERNATIONAL STANDARD 11995 First edition 1996-06-15 Aircraft Stability requirements for loading and servicing equipment Aeronefs - Exigences de stabilité des materiels de chargement et de service (so Reference number ISO 11995 1996(E) No reproduction or networking permitted without license from IHS Not for Resale S011995:1996(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International avote. International Standard IsO 11995 was prepared by Technical Committee IsO/TC 20, Aircraft and space vehicles, Subcommittee SC 9, Air cargo and ground equipment. Annex A of this International Standard is for information only. ISO1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56 . CH-1211 Geneve 20 · Switzerland Printed in Switzerland No reproduction or networking permitted without license from IHS Not for Resale CISO ISO11995:1996(E) Introduction Throughout this International Standard, the minimum essential criteria are identified by the use of the key word "shall". Recommended criteria are identified by the use of the key word "should", and while not mandatory Deviation from the recommended criteria should occur only after careful shown alternate methods to be satisfactory pyhatiganizatoStandadizatio ili No reproduction or networking permitted without license from IHS Not for Resale
ISO 11995 1996 Aircraft — Stability requirements for loading and servicing equipment
文档预览
中文文档
16 页
50 下载
1000 浏览
0 评论
309 收藏
3.0分
温馨提示:本文档共16页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
本文档由 人生无常 于 2024-09-28 08:52:47上传分享