ISO INTERNATIONAL STANDARD 11634 First edition 1996-12-15 Snowboard-boots - Interface with ski-binding Chaussures de surf des neiges - Zone de jonction avec les fixations de skis ISO Reference number ISO11634:1996(E) No reproduction or networking permited without license from IHS Not for Resale IS011634:1996(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental andnon-governmental,inliaisonwithISO,alsotakepartinthework.Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are Standard requires approval by at least 75 % of the member bodies casting a vote ISO/TC 83, Sports and recreational equipment, Subcommittee SC 3, Ski bindings. Annex A of this International Standard is for information only @ ISO 1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case Postale 56 . CH-1211 Geneve 20 . Switzerland Printed in Switzerland ed without license from IHS Not for Resale INTERNATIONAL STANDARD ISO ISO 11634:1996(E) Snowboard-boots - Interface with ski-binding 1 Scope This International Standard specifies the dimensions and characteristics of the interface zone of the sole and parts of the shaft of snowboard-boots, with an interface for clamping, to provide defined attachment conditions for the snowboard-binding. There may be other systems to attach the snowboard-boot to the board, which are not yet covered by this International Standard. It applies to snowboard-boots of sizes 15,0 and larger in the Mondopoint system. Alpine ski-boots are covered in ISO 5355[1] and touring ski-boots in ISO 9523[2] 2 Normative reference The following standard contains provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and IsO maintain registers of currently valid International Standards. tolerance indications. 3 Definitions For the purposes of this International Standard, the following definitions apply. 3.1 interface: Area which is in contact with the snowboard-binding and which provides the function of the snowboard-binding. 3.2 longitudinal median plane: Middle plane of the sole, longitudinal and perpendicular to the bearing surface. 3.3 bearing surface: Surface of the boot sole which is in contact with a plane on which the boot is standing. 4Requirements 4.1 Dimensions The snowboard-boot shall comply with the dimensions given in figure 1. For general tolerances see ISO 2768-1.