ISO INTERNATIONAL STANDARD 10284 First edition 1997-12-15 Cinematography - Graphical symbols Description Cinematographie -- Symboles graphiques - Description Organization for Standardization (Iso) Copyright License number IHS/Icc/1996. Not for resale. No part of these iso documents may be reproduced inanyform,electronic retrieval systemorotherwise,exceptas aliowed in the copyright law of the country of use, or with the prior written consent of ISo (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 734 10 79), IHs or the ISo Licensor's members. ISO Referencenumber ISO 10284:1997(E) Not for Resale ISO 10284:1997(E) Foreword isoO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. international organizations, governmental and non- governmental, in liaison with IsO, also take part in the work. isO collab- orates ciosely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO/TC 36, Cinematography. @ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. Intemational Organization for Standardization Case postale 56 : CH-1211 Geneve 20 . Switzerland Intemet [email protected] X.400 C=ch;a=400net;p=iso;0=isocs; S=central Printed in Switzerland ii Copyright byter hationalOrganizationforStandardization No reproduction or networking permited without license from IHS Not for Resale ISO 10284:1997(E) INTERNATIONAL STANDARD ISO Cinematography - Graphical symbols - Description 1 Scope This International Standard specifies graphical symbols intended for use on motion-picture equipment 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of iEC and ISO maintain registers of currently valid International Standards. equipment. Iso 7000:1989, Graphical symbols for use on equipment -- Index and synopsis. IsO 84ao:1985, Cinematography - Position of emulsion surface of 16 mm motion-picture prints - ldentification. IEC 417, Graphical symbols for use on equipment. DIN 15585:1984-12, Film printing technology; graphical symbols DiN 30600:1985-11, Graphical symbols Registration, designation 3 Dimensions Symbol dimensions shall conform to ISO 3461-1. 4 Grouping of symbols Group 1 - Symbols of general application Group 2 - Symbols of power-supply systems (electric drive) Group 3 -- Symbols of optical and lighting systems Group 4 --- Symbols of movement and mechanical systems Group 5 - Symbols of sound engineering systems Group 6 - Symbols of thermo-pneumo-hydro systems NOTE -- The equivalent French term is given below each referent. lo reproduction or Not for Resale